Reasons Why Your
Nissan Qashqai Key Fob Won't Work
The Qashqai has a distinctly SUV feel to it thanks to its larger dimensions, and the ride on 19-inch wheels in Ti and ST-L models may be firm at times. The front tyres of Qashqai can also lose grip on rough surfaces and its CVT can occasionally show wrist-flexing torque steering.
This is usually due to the battery of a coin that is dead. It is easily replaced in minutes. Make sure that the new battery has the same size, voltage and specifications.
Water Damage
One of the main reasons why a Nissan key fob gives the "key ID incorrect" message is due to water damage. The key fob comes with rubber seals which protect the chip inside, but prolonged exposure to moisture could cause it to stop functioning properly. It is common to observe this when your key fob has been dropped into the water or a swimming pool. But it can also occur when it's wet due to rain or soapy hand.
If your key fob was exposed to water for a long period of time then you might need to clean it using isopropyl or electronic cleaner. In addition, it may require taking to a specialist for repair or replacement.
If your key fob requires to be replaced, it's an easy process. Make sure you've got the correct multipack (CR2032, 3V). Remove the front and back cases with the flat-head screwdriver. Remove the metal clips, then remove the old battery and replace it. Reassemble the fob and replace the mechanical key. Check to see if it functions correctly. If it does not then you'll need to take it to a local Nissan dealer or a professional locksmith to replace the chip that controls the key. The chip is not usually damaged by water and therefore shouldn't be too expensive.
Dead Coin Battery
Another common reason the reason your
lost nissan key Qashqai key fob might not function is that the battery inside is dead. The batteries last for about three to five years, but are prone to failure over time if the fob has been dropped frequently. You could replace the battery but ensure it's the same voltage and same size as the original. If you replace the battery, it may cause the key to be assigned an incorrect key ID. This will stop it from being connected to your vehicle.
The best way to replace the coin battery on a Nissan Qashqai key fob is by removing the key fob using a small flat head screwdriver. The screwdriver needs to be inserted into a small cut on the bottom of the key fob. Gently twist the screwdriver to divide the two halves. Then, remove the old CR2025 button cell battery and insert an alternative one after taking note of its location in the fob.
Before putting the new battery in place, make sure there is no dirt or water damage on the terminals. If there is, clean the terminals using a small amount of isopropyl alcohol. You'll also need to make sure the pole cables are plugged in correctly. They must be connected to the negative and positive poles of the battery respectively.
Troubleshooting
If your Nissan Qashqai key fob stops working after exposure to clean rain or tap water, it may be a sign of an internal chip problem. You'll require a new keyfob if you can't fix the problem by changing the battery. If you dropped the key fob on the ground and it stopped working immediately it's likely due to damage to the internal chip. If you clean the chip with isopropyl ethanol and a paper towel, then replace it in the key fob, it is possible to generally get it back to working.
One common error you might see on the dashboard of your car is "Key ID Incorrect." The vehicle is unable recognize the key fob and thus won't allow the vehicle to start. This problem can be caused various ways, including water damage, problems undetectable in the key fob circuitry or RFID interference.
If the 12 volt battery in your key fob is inactive or is not supplying enough electrical current, it will stop working. This can affect the remote keyless system as well as central locking on your
nissan xterra key fob Qashqai, as well as hindering you from starting the engine with the key fob (if equipped with Intelligent Key). Check the battery in the key fob in case you are not able to lock or unlock your door by hand. You could also try re-inserting the battery to reset the transmitter.
Reprogramming
If the key fob was not submerged into saltwater, it should be able be revived with a simple rinse of clean water. You might also try cleaning your electronic chip using isopropyl Alcohol or an electronic cleaner. If none of these works, you may have to replace the key fob.
If your Nissan Intelligent Key still does not work, it could be a connection issue between it and your vehicle. Start by turning the ignition switch without starting the vehicle. Continue to do this until you see the danger lights flash twice. After that, turn the car off and take away the keys.
Open the fob compartment of your vehicle's fob compartment. It's usually found on a door jamb, or the handle for the driver's door. Find the small "program" button and press it. Once the process has been completed, you should hear a chime.
Now that your Intelligent Key is relinked to the car It's time to test it out. Make sure you press all the buttons on the key while at a distance from the car. If the lights flash and the horn beeps this means that the key is successfully linked to the
nissan qashqai replacement key cost. You can also try testing it in close proximity.